Search for Fog lights rear and front:

Fog lights are lights with yellow or white glass, which give a flat and wide horizontal beam of light. But the colour of the fog lights is not so important. The main is how they distribute the luminous flux. They provide a flat, but wide horizontal beam of light, which is distributed directly over the road not to lighten the fog. But often there are cases when the fog does not apply directly to the ground, as it occurs under conditions in which the land is warmer than the air.

The fog lights that are correctly adjusted will light not so far - about ten meters. There is no need this distance to be more, as the car is moving slowly if there is fog. Instead, they shine in all directions, as is it necessary to see the margins and painted stripes in poor visibility conditions.

It is necessary the fog lamp to have a very sharp upper boundary of the beam, since no reflected light or light from the lamp should go above the horizontal plane. This is important to provide good visibility when it is foggy. Also, the light should be mounted as low as possible to the road, because between the layer of fog and road there is a gap, on which the light should fall. Fog lights are necessary not only when it is fog. Once it was advised to turn them on when driving on narrow roads with many turns in the dark. In such conditions, the speed is low, but they light sideways. Today, in some cars the main lights turn right after the steering is turned.

Do you need fog lights? In our online store there is a great variety of fog lights for all car models. And the main advantage is moderate price. Our couriers will deliver your purchase in any convenient location. Also, in our online shop you can order wiper rubber, tie rod and flywheel.

What you need to know about fog light replacement: lifetime limits, common defects and their signs, tips and recommendations

The fog light has no certain lifetime limit and is replaced in case of breakdown. The component can lose its serviceability in case of oxidation or thermal damage of contacts, reflector wear-out, damage of glass or housing. In case of defects one of front or rear fog lights doesn’t light up or gets dimmer.

You can assess details condition visually. If the component doesn’t function while there are no visual damages, then you should check the signal going to it and measure voltage and current rate as well. If you couldn’t find out defect cause using this method, then apply to a service station. The thing is that unqualified actions at checking fog lights can lead to damage of low and high beam light power circuit.

For replacement of the front left fog light you should demount the bumper, engine mudguard from the respective side, then unscrew fixations, disconnect the wiring harness and remove the defective component. Then install a new fog light and perform assembling in the reverse order. In order to replace the rear fog light sometimes you should also demount the bumper, unscrew light fixations, disconnect the wiring harness and after that install a new component and perform assembling. You should buy the fog light kit for replacement: using both old and new light can negatively influence lighting quality.