Find a Hoses & pipes:
Hoses & pipes - Find your car parts
Information - Hoses & pipes
Hoses are necessary to feed the fluids and gases system. As a rule, the hoses are fixed with special clamps. Hoses can leak because of wear or mechanical damage. Usually, it is required to change them. In order to get to the service centre, the hoses can be taped with a special adhesive tape. When we speak about repair of the systems that ensure safety driving, such as hydraulic brakes, it must be done only by a qualified technician.
If the leak occurred in a closed system, it could be a leaking hose. But it is not so easy to find the leakage. Even if it is a small hole, you should carefully check all hoses. If the damage is detected, the faulty hose can be relatively easily replaced. At the same time it is usually required to drain at least a part of the fluid from liquid systems. Then you can again fill the system with the necessary liquid. Vacuum systems need special equipment.
Therefore, in the case of systems related to driving safety, they must be repaired by qualified professionals. Even if the cost of hose replacement exceeds the cost of the hoses, do not try to repair brake hydraulics by yourself. Improperly installed hose can easily lead to failure of brakes. If the problem is not related to systems, which provide safety, a skilled motorist can replace the hoses without any assistance. A good help can be a repair manual. The Internet is also a source of useful information on car repair.
Hoses & pipes at low cost: Top Spares
- Material: EPDM (ethylene propylene diene Monomer (M-class) rubber)
- Condition: New
- Weight [kg]: 0,09
- Left-/right-hand drive vehicles: for left-hand drive vehicles
- Supplementary Info: Q+, original equipment manufacturer quality MADE IN GERMANY
- Packaging width [cm]: 30,2
- Packaging height [cm]: 6,2
- Packaging Depth [cm]: 66,8
- Condition: New
- Thickness [mm]: 4
- Inner diameter [mm]: 32
- Colour: Black
- Material: NBR (nitrile butadiene rubber)
- Weight [kg]: 0,001
- Condition: New
- Cooling Hose: from engine cooler to water pump
- Material: 6
- Supplementary Article/Supplementary Info: 35
- Condition: New
- Material: Elastomer
- Diameter 1 [mm]: 32
- Thickness 1 [mm]: 4
- Fit: Universal
- Condition: New
- Material: 6
- Supplementary Article/Supplementary Info: 35, with seal
- Condition: New
- Weight [kg]: 0,062
- Supplementary Info: Q+, original equipment manufacturer quality MADE IN GERMANY
- Packaging width [cm]: 10
- Packaging height [cm]: 3
- Packaging Depth [cm]: 19
- Condition: New
- Hose Length [mm]: 459
- Material: EPDM (ethylene propylene diene Monomer (M-class) rubber)
- Colour: Black
- Inner diameter 2 [mm]: 34, 39
- Condition: New
- Material: Elastomer
- Diameter 1 [mm]: 15
- Thickness 1 [mm]: 2,62
- Fit: Universal
- Condition: New
- Supplementary Info: Q+, original equipment manufacturer quality
- Fitting Position: Lower
- Cooling Hose: from engine cooler to water pump
- Weight [kg]: 0,16
- Packaging width [cm]: 9,5
- Packaging height [cm]: 6,8
- Packaging Depth [cm]: 23,1
- Condition: New
- Length [mm]: 342
- Cooling Hose: from thermostat to waterpump
- Material: Plastic
- Weight [kg]: 0,134
- Supplementary Article/Info 2: with seal ring, with bracket
- Condition: New
- Fitting Position: Lower Right
- Cooling Hose: from thermostat to radiator
- for OE number: 11 53 1 436 408
- Weight [kg]: 0,321
- Condition: New
