Search for Wiper linkage rear and front:

Wiper pull rods in all cars are interconnected and attached to the gear reducer crank with the help of joints. To replace the wiper pull rods you need a screwdriver. It is not difficult to do without any assistance. We will tell you what the order of actions is.

First, you need to remove the windscreen wipers and then the gear reducer. After this you need to disconnect the rods. To do this, remove the rod hinge stopper from the crank axle groove. Under the rod there are flat washer and spring washers. The same way disassemble the second hinge and remove the rod. At that the process of the wiper pull rod removal is finished. You need only to install new rods in the reverse order. When installing the gear reducer, be sure to pay attention to the state of the rubber sleeves on the bracket. If necessary, replace them with new.

If you need to replace the wiper pull rods, do not waste time for shops and garages. You will just lose your time and overpay for the spare part. It is better to visit our online shop. We offer our buyers a wide range of wiper pull rods for any make of car. Order the parts you need at a reasonable price. We will ensure the delivery to be done in a short term. In addition to wiper pull rods, here you have possibility to purchase many other spare car parts, like wiper arm, wiper blades or windscreen wiper.

What you need to know about windscreen wiper linkage replacement: lifetime limits, common defects and their signs, tips and recommendations

Operational lifetime of the windscreen wiper linkage is not limited by manufacturers. The component is replaced at breakdown, usually, due to abrasion or deformation of the plastic bush or hinged elements.

Defectiveness of the part is indicated by failures in windscreen wiper operation. For example, during cleaning, wipers can move too slowly or stop, operate with jerks. Moreover, specific sound (knocking, buzzing) is often heard during their operation.

Diagnostics of the windscreen wiper links and arms system presupposes its visual inspection. If you notice free play when swaying the wiper arms that spontaneously stopped, this indicates breakdown of a link of the windscreen wiper linkage. You can make sure that the problem lies in the linkage and estimate component damage degree by disassembling the unit. It is possible that some car body elements require dismantling in order to gain access to the windscreen wiper mechanism. That is why you’d better address to a service station for diagnostics and replacement of the component.

At this procedure, electric circuits of the car will be de-energized, and the linkage – disconnected from the motor. For replacement of the component: unscrew the windscreen wiper arms; and in most cases, the cowl cover and the cowl top panel are demounted as well. Actions sequence depends on constructional features of a specific car model. During assembling completion treat all parts and units with graphite grease, perform adjustment of the wipers, and check windscreen wiper operation in all modes.