Search for Coolant flange :
Coolant flange for automobile
Choose your car and find high-quality Water outlet
- TOYOTA
- Coolant flange for YARIS
- AVENSIS
- RAV 4
- VOLVO
- Coolant flange for XC60
- XC 90
- V70
- MINI
- Hatchback
- COUNTRYMAN
- CLUBMAN
- LAND ROVER
- RANGE ROVER
- DISCOVERY
- FREELANDER
Information - Coolant flange
Over time, each car owner notices that the level of antifreeze gets gradually reduced. But there are no large puddles under the car. The most affected are vehicles with engines equipped with plastic flanges in the cooling system. Time and temperature fluctuations may cause leakage of antifreeze. First – drop by drop, then – more seriously.
The motor flange is considered one of the most probable reasons of antifreeze leakage. Often there are no visible traces of this, because the coolant evaporates relatively quickly from the hot block. But on the flange mounting bolts traces of leakage can always be seen with the naked eye.
If antifreeze stains suddenly appear next to the cooling system, you should immediately think of buying a spare flange, preferably an original one. This item is relatively cheap, but very demanding and important, since the operating temperature mode of the engine depends on it. And do not forget that a faulty flange leads to leakage of coolant and engine overheating, and these are additional unnecessary worries and expenses.
If you need to replace the coolant flange, do not waste your time for visits to repair shops or garages. You will not just waste time, but also significantly overpay for the necessary part. Visit our online store without leaving your home or office. We offer to our customers a wide range of flanges for any car brand. Benefit from our low prices, order the required part and we will deliver it in a short time. Apart from coolant flanges, you can also purchase other replacement parts for your vehicle, for example main brake cylinder, clutch pressure disk, water pump, washer or flywheel.
What you need to know about a coolant flange replacement: lifetime limits, common defects and their signs, tips and recommendations
A coolant flange doesn’t have a specified service life. Component is replaced in case of mechanical damages which lead to system depressurization.
Coolant flange defects are indicated by cooling fluid leakage. In this case engine overheating often takes place: a corresponding indicator is active on the dashboard. Also, an antifreeze smell can appear in the passenger compartment.
For coolant flange diagnostics you should inspect the unit for damages and stains. It is better to visit a service station for this. On many cars access to the coolant flange, T-pipe and other components of the cooling system can be troubled: in order to inspect them one will need to demount some other car parts.
It is better to entrust installation of a new coolant flange to professionals with special tools. Before component replacement one needs to drain coolant from the system, disconnect the coolant temperature sensor. Non-qualified flange installation can cause engine overheating during driving.
Best goods: Coolant flange
- Material: Aluminium
- Supplementary Article / Supplementary Info: with seal
- Condition: New
- Inner Diameter [mm]: 19,5
- Material: NBR (nitrile butadiene rubber)
- Weight [kg]: 0,003
- Condition: New
- Weight [kg]: 0,15
- Fitting Position: Cylinder Head
- Supplementary Info: Original VAICO Quality
- Packaging height [cm]: 7,8
- Packaging Depth [cm]: 12,5
- Condition: New
- Weight [kg]: 0,153
- Supplementary Article / Supplementary Info: with seal
- for OE number: 038 121 132 D
- Condition: New
- Supplementary Article / Supplementary Info: with seal
- Supplementary Info: ORIGINAL Quality
- Condition: New
- Weight [kg]: 0,092
- Supplementary Article / Supplementary Info: with seal
- for OE number: 11 11 7 800 048
- Condition: New
- Supplementary Article / Supplementary Info: with seal
- Fitting Position: Upper Left, Cylinder Head
- Product line: -ORIGINAL Quality
- Condition: New
- Thickness [mm]: 3,5
- Inner Diameter [mm]: 19,5
- Material: NBR (nitrile butadiene rubber)
- Weight [kg]: 0,003
- Condition: New
- Diameter [mm]: 20
- Condition: New
- Shape: T Shape (T Piece)
- Number of inlets/outlets: 3
- Angle [°]: 90
- Material: GRP (Glass fibre Reinforced Plastic)
- for pipe diameter [mm]: 9, 13
- for OE number: 074 121 438C
- Condition: New
- Weight [kg]: 0,076
- for OE number: 11 12 7 806 196
- Supplementary Article / Supplementary Info: with seal
- Condition: New
- Material: Plastic
- Weight [kg]: 0,015
- Condition: New